High Quality Pressure Cleaning in Port Reading, NJ for the Best Value

Power washers are fairly simple to operate once you know what you're doing. First of all, the power source in most cases will be a gas tank, rarely are the electrical units used for obvious reasons. Then with pressure cleaning in Port Reading, NJ a source of water is required, most commonly in the form of an ordinary garden hose. Once the fuel and water are hooked up, the nozzle is attached. Without a cap to the nozzle, essentially the unit becomes a soap dispenser. There isn't much power involved when simply soaking the area. Now, there are varying degrees of power in each nozzle cap. A cap with an angle of 45 degrees is more effectively used as a pressurized water broom, sweeping away dirt and grime with ease. This would be for larger areas being targeted that don't look terrible and have no deep stains, just light debris and soil. Go with a 15 degree endcap to add a little more power into your pressure cleaning. Port Reading, NJ is fortunate enough to have access to these types of cleaning equipment. This nozzle accessory will remove caked on gum off a concrete slab in no time at all. And finally, for the most power, simply go with a cap without any degree of spray at all. At 0 degrees the force of this piece is strong enough to cut through human skin with the water. This part should never be implemented unless the material it's being used against can afford to lose its top layer. For extreme cases however, this cap is extremely useful. I can tear mold right off your home's siding or dial back a paint job to a shade lighter.

Firstly, and always, we disconnect the nozzle from the gas unit. We then clear the nozzle with a special clip that is dragged through the body of the unit. After flushing the nozzle with water, it's as simple as reconnecting the nozzle to the washer's hose again.